![]() If this doesn’t happen, remove the ball and O-ring again. Shake the injector kit, and if the ball drops out, it means it’s working fine. First, install the O-ring and then put the ball inside the bore. Check the components, and replace them if they are really worn out.īefore assembling the (new) ring and ball, apply some grease on them so that the ball doesn’t get stuck with the ring. You should find the conical spring and a metal ball. Disassemble the components from the soap injector system. Loosen the screws using a wrench and remove it from the pressure washer. ![]() The soap injector kit is usually located near the pressure pump. To examine the soap injector kit, remove it from the pressure washer. If any of these components are faulty, then your soap dispenser system won’t work correctly. The main components of the soap injector are the O-ring, conical spring, ball, and injector. The soap injector is the part that is used to mix the soap with the high-pressure water that goes to the spray nozzle.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |